About this service
Security lighting improves visibility around entrances, side paths, parking areas and vulnerable boundaries. It should reveal movement and support cameras or safe access without creating constant glare or lighting neighbouring property.
Controls may include PIR movement sensors, photocells, timers and manual overrides. Positioning and setup are critical because a good fitting can still perform badly if the sensor sees a public footpath, moving trees or heat source.
Common problems we help with
Light stays on all night
Sensor settings, manual override, wiring faults or an unsuitable detection field may be responsible.
Frequent false triggering
Road traffic, animals, vegetation, reflective surfaces and heat sources can activate a poorly aimed PIR.
Dark approaches remain unlit
A fitting may be too high, badly aimed or blocked by the building layout.
Old floodlight uses excessive power
High-wattage halogen fittings can be replaced with controlled LED equipment.
How we carry out the work
Identify the useful coverage
We consider doors, paths, gates, camera views and areas where people need safe visibility.
Choose position and control
Detection angle, mounting height, neighbouring property and manual control are agreed.
Install and commission
The circuit is tested, then time, sensitivity and daylight settings are adjusted in real conditions.
What is normally included?
- Initial discussion about the property, symptoms, priorities and timescale
- Assessment of the relevant circuit, equipment, access and existing protection
- A written scope for the proposed security lighting work
- The agreed installation or repair work, with disruption kept to a reasonable minimum
- Inspection, electrical testing and appropriate handover documentation
Before the work starts
- The task, atmosphere and useful light level required in each zone
- Colour temperature, glare, dimming and compatibility between fittings and controls
- Maintenance access and replacement availability
- Outdoor exposure, emergency duration or security coverage where relevant
What affects the price?
The price depends on the existing installation and the amount of work required. For security lighting, the main factors normally include:
- Fitting quantity and specification
- New switching, control or circuit requirements
- Working height and access equipment
- Making good, containment and removal of obsolete fittings
Testing, certificates and handover
Once the installation work is complete, we inspect and test it and provide the records that apply to the job.
- Demonstration of dimming, sensors or programmed controls
- Circuit testing and applicable certification
- Luminaire and driver information
- Maintenance and replacement guidance
Security Lighting questions
What is the best height for a PIR light?
It depends on the fitting’s detection pattern and the area being covered. Manufacturer guidance and site layout should be used.
Can a security light share a lighting circuit?
Sometimes, provided the circuit and switching arrangement are suitable.
Will it work with CCTV?
Yes, but the light level, direction and camera exposure need to be considered together.
Booking the work
What happens after you contact us
1. Discuss the job
Tell us about the property, the symptoms or the result you want. Photographs and model numbers are often helpful.
2. Inspect and quote
We check the relevant installation and give you a written quotation showing what is included.
3. Complete and test
We carry out the agreed work, verify it electrically and explain any controls, labels or certificates at handover.